Natural Stone / September 6, 2018 / FifineAsselin
The second step is washing. All the tiles must be washed with water and soap and they must be free of any dirt grout or tile adhesive. After washing you must allow the tiles to be dried for two to four weeks depending on the season. In winter it takes more time for the tiles to be dried so it takes more time and during the summer the tiles get dry quicker so one to two weeks would be fine. The last step is sealing. Sealing is like applying a layer of glue on top of the tiles to protect the surface from dirt and water absorption. Sealers are quite pricy however; it is worth it to spend some money to protect your beautiful natural stone.
Let us get into the details about the three points to be considered during the purchase: Solidity: This is pretty an easy thing to measure and people can judge the solidity of the product by breaking it. If it is hard to break the buyer can be satisfied that he has the right natural stone in his hand. Also he can try to drop a hammer from a good height for testing whether it breaks. In some showrooms there will be a separate space for conducting this type of tests on the stones. The dealers provide this sort of space just because of the fact that they are highly confident about the quality of the product that they deal with. If it is of the best quality there will not even be a mark of the hammer.
Using the edge of a trowel generously fill in the gaps between your tiles (created by using spacers) and smooth it over the surface at a 45 degree angle to the floor. A grout profiling tool can help after youve applied the grout to smooth the fill off and remove any unwanted excess. Caring for your natural stone tiles it an important to remember and before you finish your tiling job you need to seal the tiles to prevent the stone from becoming stained. This seal needs to be applied after tiles have been cleaned and any residual dust adhesive or grout has been removed with a residual remover. After applying and removing the residual remover a seal can then be added to help prevent materials and liquids from entering the pores of the stone and leaving potential marks. This seal needs to be regularly maintained in order to keep the tiles in good condition and can even be added to through the use of enhancing products to bring out the natural grain and contrasts of the stone.