Natural Stone / September 3, 2018 / FifineAsselin.
Using the edge of a trowel generously fill in the gaps between your tiles (created by using spacers) and smooth it over the surface at a 45 degree angle to the floor. A grout profiling tool can help after youve applied the grout to smooth the fill off and remove any unwanted excess. Caring for your natural stone tiles it an important to remember and before you finish your tiling job you need to seal the tiles to prevent the stone from becoming stained. This seal needs to be applied after tiles have been cleaned and any residual dust adhesive or grout has been removed with a residual remover. After applying and removing the residual remover a seal can then be added to help prevent materials and liquids from entering the pores of the stone and leaving potential marks. This seal needs to be regularly maintained in order to keep the tiles in good condition and can even be added to through the use of enhancing products to bring out the natural grain and contrasts of the stone.
This is because they are very easy to clean as all you really need is a mop and water to give them a quick wipe on a regular basis. As well as being more convenient this also means that they are a very hygienic option for your floor. If the tiles are sealed they will be non-porous helping to keep out bacteria. If you are seeking an alternative tile for your floor and want to achieve a high quality and sophisticated finish natural stone tiles are perfect. When you choose natural floor tiles you will find that you still have plenty of options in terms of materials including sandstone marble granite flagstone and so much more.
First of all due to the high quality and fact that it is a natural material natural stone can be more expensive than other solutions. They also can be more difficult to fit and maintain which can also increase the cost. One factor with fitting natural stone tiles is that they can be more difficult to cut when tiling around fixtures and fittings. The best way to cut stone tiles is to use an electric wet tile cutter and preferably to do this outside or in a prepared environment due to the potential to get water and debris spray. When fitting natural stone tiles it is also important to seal the tiles after fitting as this may otherwise result in the stone becoming stained.
They should then explain in detail what they are looking for when they do the remodel. It is best for the homeowner if they have specific ideas and plans laid out so that the contractor fully understands what they are getting themselves into. When telling the contractor of your plans be sure to tell them that you want to use natural stone tiles. This way if the contractor has some sort of hesitation about working with the material you can cross that contractor off your list for those that you are considering hiring for your remodel. Natural stone tiles usually do not make contractors want to run from a project however some contractors may just not like working with the material since it does require a few extra tools that they may or may not have on hand. Once you get all of the information from the contractors and have narrowed down the list of just who can work with the materials that you have specified.