Metal Tile / September 13, 2018 / FifineAsselin
The coatings are designed to reduce energy use within the home by reflecting the heat of the sun. This will help offset the initial investment by avoiding costly repairs while saving you money over the course of time. Metal tile roofing has doubled in the past five years with a growth rate of about 15% annually. This is because the material itself is more capable of protecting your home against destructive weather conditions. To prove that studies have shown that it can last at least two to three times longer than an asphalt roof. That is about 40 to 60 years. Since it is also given anti-rusting treatment it will not corrode. The world is well aware of climate change. Another benefit of it is that when it is damaged it can by recycled and used again.
The metal tile roofing is highly durable in nature and can last two or three times longer than other types of roofing made of asphalt or wood. Moreover the anticorrosion and anti rust properties make it last longer for over 40 to 60 years. Not only this the material used for making this roof is environment-friendly and can be recycled easily. It also does not require any chemical treatment to save it from rot or insects and helps in protecting the environment. Its available in different colors and shade and can easily find one that can fit with the color scheme of your walls. The metal roof tiling provides a cooling effect to your house thus saving energy.
The smaller rod is used to fix batons around hips and valleys and saves a lot of time messing around with a tape. Cutting and bending At roof terminations and intersections tiles are cut to fit allowing for a 50mm bend in the tile. It is this turn up/down that provides the waterproofing of the roof. It is important to bend a sufficient upturn or water may be blown under the ridge or hip. I have found by taping the jaws of the bender with several layers of duct tape it allows the tiles to be gripped firmer without damaging the paint of the tile. Aim to use half the tile per cut. This will leave you enough metal to get another cut for the opposing side. Valley cutting Marking and cutting the valley at ground level gives a much neater appearance. Instead of measuring each tile cut individually the tiles are laid along the ground as if they were on the roof.