Metal Tile / September 13, 2018 / FifineAsselin
Setting out Setting out the roofing before installation is a major part of any new roof build. With metal tile roofing it is imperative to get the correct gauge right from the start. Unlike concrete tiles that have a certain amount of play in the gauge measurements metal tiles have to be spot on or they will not fit. For this reason it is common practice to use set out pins to ensure accurate fixing of the batons. A measuring stick is used to mark the gauge up the rafter before driving in the set out pins. The batons are then cut in place before being lifted clear to allow the building paper to be laid. It is possible to cut down the setting out time by half by building a separate smaller gauging rod.
You just have to go up there and sweep away accumulated leaves or other debris and inspect the roof top ancillaries and air conditioners to be sure that it is properly drained and supported. You also save money when it is time to pay your income tax thanks to the US energy Policy Act of 2005. This allows homeowners a tax credit when they decide to use it in their homes as long as they meet the Energy Star program requirements. It is available in different colors. This means you will be able to find one that matches the color of your walls. If you want to change it you dont have to replace the entire thing but simply paint over the old color. Should you decide to get metal tile roofing make sure you get a warranty from the manufacturer.
The tiles must be tight and correctly aligned. The bottom and top course is then marked using a bevel. Two people may now chalk a line along the length of the valley. This gives a much straighter line than individual measurements. Laying the tiles Contrary to other roofing practices pressed steel tiles are best laid from the ridge down. Lay the under lap into the prevailing wind. This will ensure the maximum wind resistance and stop the roof lifting. The first full top course is laid out and fixed at the head of the tile allowing the subsequent row to be slid underneath the bottom. It is important to even out the tiles to make the best use of the cut ends.