Glass Tile / January 24, 2019 / Genevieve Brunelle
There normally is not a concern with seeing the mesh backing through this tile. The same precautions still need to be taken into consideration for installation as well. The last thing to take into consideration is the grout. To play it safe the best grout to use is either an un sanded grout or specialty grout. The reason you will wand an un sanded grout is there is no sand particles in the unsanded grout. Sand particles found in sanded grout can possibly scratch the surface of the glass. The specialty grouts do not have any sand particles in them including the epoxy grout and urethane grouts. Home owners who want to make their kitchen pools or bathrooms look good often consider using glass tile. However these tiles can be quite pricey and can end up costing a person more when it comes to construction and renovation projects.
Installing glass tile is a great way to enhance your kitchen bathroom or pool remodeling project. With such a huge variety of colors shapes and styles this type of tile makes the perfect choice for an elegant solution to any designing theme. Add in the fact that these tiles are one of the most affordable tile products on the market today and its hard not to see why its such a popular element in home design. Before beginning any glass tile grouting project the affixed tiles must have been allowed to cure for 36-48 hours. Any debris should be removed using a brush or shop vacuum. Use a wet sponge to remove any exposed thin-set that may have cured to the tiles.
In situations where glass tile is exposed to extreme temperature differences an elasticizing polymer is added to the mix allowing the grout to stretch and flex preventing breaks from occurring in the delicate glass tiles. Using a grout float scoop a manageable amount of grout onto the float. Start at the farthest or highest spot away from you and spread the grout in between the tiles diagonally across the pattern. Dont worry about getting grout all over the tiles. The grout must be firmly pressed into the grout lines with the grout float covering all spaces and voids. Once a 3x3 section of grout has been applied to the tile use the small rubber edge of the grout float to remove about a third of the grout from between the tiles.