Glass Tile / January 24, 2019 / Karlotta Boule
Consumers need to consider that many mesh backed material use poor quality glue to bond the tile to the mesh. When the mesh side is installed to the surface the mesh acts as a barrier between the tile and substrate. If the glue subsequently breaks down or the bond fails the tile can then easily loosen and fall out because little of the tile surface is actually bonded to the substrate. This failure can begin almost immediately or can take up to a few years after all installation warranties have expired. With Chinese produced glass tile my experience has shown the glue used to bond the tile to the mesh is lower in quality than the glue used in higher quality products produced in Europe or quality US manufacturers.
Both trendy and good for the earth read on to learn why your next decorating project should involve recycled glass tiles. One of the benefits of recycled tile is that the abundance of wasted glass in landfills is put to good use leaving the land free to be utilized for more biodegradable material. (This also means that landfills dont need to be expanded to accommodate the rising amount of glass waste.) Recycled glass tile is also better for the environment because it takes take less than half the energy required to produce other forms of tile. Additionally when you move on to other decorating themes you can re-recycle your recycled tiles too! Recycled glass tile is easy to install easy to clean and looks great in any room including shower stalls bathroom and kitchen floors as well as backsplash areas.
The reason so much more grout is removed than when grouting conventional tile is because light refracts better through the glass tile when the sides of the tiles are exposed to the light. Work 3x3 spaces for about ½ hour or until the grout begins to dry then sponge off the grout. Bring several buckets of clean water and a sponge to the work area before you begin. Soak up some water into the sponge and gently wipe away the excess grout that is adhered to the tile. Smooth the grout lines with the sponge using one continuous swipe. Flip the sponge over and swipe more grout from the tiles until it becomes full of grout. Rinse the sponge in a clean bucket of water and repeat.