Glass Tile / January 14, 2019 / Morgana Faubert
Often glass tiles are translucent in appearance and any imperfection in either the setting application or the thinset is magnified. Whichever tile is being installed the substrate must be perfectly smooth using the manufacturers suggested setting materials and following their instructions exactly as written. Any "waves or grooves" in setting material are noticeable which is another reason a consumer needs to hire a contractor trained in glass tile installation. Another major quality difference between glass tiles is in the quality of the glass used during production. Oceanside Glass is famous for using recycled bottles in its production and provides consumers with a guide of how much post-consumer recycled material are used in their production and can assist with LEED accreditation. Additionally their state-of-the-art equipment for precision processing in batching changing furnaces and cooling molten glass is revolutionary.
Choosing the right grout color to match your glass tile is essential to preventing blemishes and imperfections from being easily spotted. Because of the reflective surfaces on these tiles grout can disrupt the refraction of light easily catching the eye and revealing blemishes in the tiles. A suitable match is one that is similar in color to the tiles color. Mixing grout is as simple as making pancake batter. Use a paddle bit and a ½" drill to mix non-sanded grout into a five gallon bucket stirring in water slowly. Once the mix has achieved the consistency of pancake batter the grout will be mixed to perfection. Add more water or more grout as needed to thin or thicken the grout mix.
In situations where glass tile is exposed to extreme temperature differences an elasticizing polymer is added to the mix allowing the grout to stretch and flex preventing breaks from occurring in the delicate glass tiles. Using a grout float scoop a manageable amount of grout onto the float. Start at the farthest or highest spot away from you and spread the grout in between the tiles diagonally across the pattern. Dont worry about getting grout all over the tiles. The grout must be firmly pressed into the grout lines with the grout float covering all spaces and voids. Once a 3x3 section of grout has been applied to the tile use the small rubber edge of the grout float to remove about a third of the grout from between the tiles.