Glass Tile / January 5, 2019 / Genevieve Brunelle
Clean water is the key to finishing the job quickly and thoroughly. Once the tiles have been cleaned check for any voids or pits and fill them in as needed. Use the sponge and clean water to wipe away any remaining grout. Allow to dry for a few hours and then use a dry cheese cloth to clean the remaining grout residue. After the glass tile has dried for 48 hours its ready for use! Glass tile is not only beautiful to look at its also quite versatile. The Romans were known to use mosaic tiles all over their empire to create a feeling of home and to add religious pictorial and decorative significance to rooms of their homes. So if youd like to do as the Romans did get yourself some tiles.
The reason for doing this is when installing the glass tiles you do not want to see the trowel marks through the glass tiles. Another key to think about when installing the translucent tile is to make sure the surface behind the tile is white. If you have a painted kitchen and the walls are currently a dark or strong color that color could appear through the glass tile. If installing the translucent tile make sure the surface is painted white first and make sure the use of white thin set as well. The second type of glass is where the glass itself is a crystal type glass with the color backed on the back. Most 4mm or 8mm crystal type glass is clear and then the color of the tile is applied on the back of the tile giving it the color.
Consumers need to consider that many mesh backed material use poor quality glue to bond the tile to the mesh. When the mesh side is installed to the surface the mesh acts as a barrier between the tile and substrate. If the glue subsequently breaks down or the bond fails the tile can then easily loosen and fall out because little of the tile surface is actually bonded to the substrate. This failure can begin almost immediately or can take up to a few years after all installation warranties have expired. With Chinese produced glass tile my experience has shown the glue used to bond the tile to the mesh is lower in quality than the glue used in higher quality products produced in Europe or quality US manufacturers.