Glass Tile / January 22, 2019 / Odette Pinneau
Consumers need to consider that many mesh backed material use poor quality glue to bond the tile to the mesh. When the mesh side is installed to the surface the mesh acts as a barrier between the tile and substrate. If the glue subsequently breaks down or the bond fails the tile can then easily loosen and fall out because little of the tile surface is actually bonded to the substrate. This failure can begin almost immediately or can take up to a few years after all installation warranties have expired. With Chinese produced glass tile my experience has shown the glue used to bond the tile to the mesh is lower in quality than the glue used in higher quality products produced in Europe or quality US manufacturers.
In this method colors are added to the top or bottom of the glass. Fused glass tiles are characterized with a translucent area and a layer of opaque color visible through the tile. These tiles are further treated with an etching or other coating for aesthetics or abrasion. Sintered tile is a variety made by pressing glass powder into dies and then heated until the particles fuse. The color is either added into the powder or added topically after cooling. Unlike smalti tiles sintered tiles tend to have a uniform look. This milky and scratch-resistant finish makes it versatile. Cast tile is made by inserting chunks of glass into a mold which gives it a layered look.
The first type of tile is a translucent glass. A translucent glass is a type of tile that you could actually hold up and see right through it. The most common types of glass that is translucent is a recycled glass or an oval penny round or brick type of tile. Majority of translucent glass tiles are paper faced. The reason that most of these are paper faced is because the mesh backing can be seen through the glass tile. When installing this type of glass tile you want to use a small notch trowel when spreading your mastic on the installation surface. After spreading the mastic you will want to flatten down or knock down the trowel marks.