Metal Tile / September 13, 2018 / FifineAsselin.
When it come to doing up ones home tiles are the most commonest items that have been around for quite some time. Until recently it was only glass or ceramic tile that was mostly used and easily accessible affordable and easy to maintain. With the economic growth and the increase in the earning potential of the customers the will and the capacity to spend on decent and classy homes has increased. Things which are out of fashion or out of date do not attract people because they want their living spaces to be different and classic. The metal wall and roof tile has attracted everybodys attention. The different metals that are used for this purpose are copper bronze zinc and steel.
The smaller rod is used to fix batons around hips and valleys and saves a lot of time messing around with a tape. Cutting and bending At roof terminations and intersections tiles are cut to fit allowing for a 50mm bend in the tile. It is this turn up/down that provides the waterproofing of the roof. It is important to bend a sufficient upturn or water may be blown under the ridge or hip. I have found by taping the jaws of the bender with several layers of duct tape it allows the tiles to be gripped firmer without damaging the paint of the tile. Aim to use half the tile per cut. This will leave you enough metal to get another cut for the opposing side. Valley cutting Marking and cutting the valley at ground level gives a much neater appearance. Instead of measuring each tile cut individually the tiles are laid along the ground as if they were on the roof.
The tiles must be tight and correctly aligned. The bottom and top course is then marked using a bevel. Two people may now chalk a line along the length of the valley. This gives a much straighter line than individual measurements. Laying the tiles Contrary to other roofing practices pressed steel tiles are best laid from the ridge down. Lay the under lap into the prevailing wind. This will ensure the maximum wind resistance and stop the roof lifting. The first full top course is laid out and fixed at the head of the tile allowing the subsequent row to be slid underneath the bottom. It is important to even out the tiles to make the best use of the cut ends.
As for maintenance all you have to do is make sure that no acidic food items such as tomatoes coffee vinegar and such stays on the surface for too long or it will fade the colors of the metal. Like stainless steel a tile backsplash of metal is also one of the most expensive and need a lot of detail during installation. Therefore you would also need to hire the services of a professional to make sure that you get every little tile placed exactly where it should be. If you want to get metal tiles for your backsplash here is one basic thing to remember: metal tile backsplash is almost like stainless steel with more choices when it comes to color and more flexible when it comes to patterns.