Glass Tile / January 5, 2019 / Morgana Faubert
Clean water is the key to finishing the job quickly and thoroughly. Once the tiles have been cleaned check for any voids or pits and fill them in as needed. Use the sponge and clean water to wipe away any remaining grout. Allow to dry for a few hours and then use a dry cheese cloth to clean the remaining grout residue. After the glass tile has dried for 48 hours its ready for use! Glass tile is not only beautiful to look at its also quite versatile. The Romans were known to use mosaic tiles all over their empire to create a feeling of home and to add religious pictorial and decorative significance to rooms of their homes. So if youd like to do as the Romans did get yourself some tiles.
For the past five years I have witnessed an unprecedented increase in the use of glass tile mosaics in residential and commercial applications. As with many other high end popular products cheaper knock-offs have quickly flooded the market. Unsuspecting consumers purchase these attractive-looking cheap tiles only to become frustrated months later when they learn the investment in their home is not only worthless but also costly. When a glass tile installation or product fails homeowners are left with expensive tear-outs and repairs. To the end user and many untrained contractors the quality differences may seem subtle but these distinctions have a major impact on the final appearance and durability of the project.
In situations where glass tile is exposed to extreme temperature differences an elasticizing polymer is added to the mix allowing the grout to stretch and flex preventing breaks from occurring in the delicate glass tiles. Using a grout float scoop a manageable amount of grout onto the float. Start at the farthest or highest spot away from you and spread the grout in between the tiles diagonally across the pattern. Dont worry about getting grout all over the tiles. The grout must be firmly pressed into the grout lines with the grout float covering all spaces and voids. Once a 3x3 section of grout has been applied to the tile use the small rubber edge of the grout float to remove about a third of the grout from between the tiles.