Glass Tile / January 19, 2019 / Fleurette Theriault
Consumers need to consider that many mesh backed material use poor quality glue to bond the tile to the mesh. When the mesh side is installed to the surface the mesh acts as a barrier between the tile and substrate. If the glue subsequently breaks down or the bond fails the tile can then easily loosen and fall out because little of the tile surface is actually bonded to the substrate. This failure can begin almost immediately or can take up to a few years after all installation warranties have expired. With Chinese produced glass tile my experience has shown the glue used to bond the tile to the mesh is lower in quality than the glue used in higher quality products produced in Europe or quality US manufacturers.
Instead as art glass grows in popularity and the internet is increasingly adopted as a low-cost distribution and promotion mechanism we are seeing a trend towards glass art collectives and glass art dealers on the web. These organizations showcase the work of several artists; and provide services that range from simple sales channels to design support for integrated glass design for the home. An example of such a service is the Glass Artists Gallery . They have been helping designers and homeowners all across North America with art glass tiles lighting sinks and other functional glass art for years. They are not really a "brick and mortar gallery" but rather a resource for the trade and discerning homeowners for functional and architectural glass.
The first type of tile is a translucent glass. A translucent glass is a type of tile that you could actually hold up and see right through it. The most common types of glass that is translucent is a recycled glass or an oval penny round or brick type of tile. Majority of translucent glass tiles are paper faced. The reason that most of these are paper faced is because the mesh backing can be seen through the glass tile. When installing this type of glass tile you want to use a small notch trowel when spreading your mastic on the installation surface. After spreading the mastic you will want to flatten down or knock down the trowel marks.