Glass Tile / January 6, 2019 / Fealty Allaire
Glass tiles are essentially pieces of glass formed into consistent shapes. Glass mosaic tiles are suitable for both internal and external applications as they are impervious to frost sunlight and water. This quality makes it best suited for wet or constantly submerged areas. They are easy to clean maintain and they never discolor. Glass tiles have a varied application in black slashes of drawing-room dining kitchen bath-room etc... They are also used to highlight certain features. The spot lighting has further increased their use. Although glass tiles are complex to install the benefits and beauty makes us over see. Production methods determine look and feel of a glass tile. There are four major types of glass tile based on their manufacturing method. They are smalti fused sintered and cast.
What that means is glass expands and contracts at a greater rate than other materials someone might use in their pool e.g. ceramic or stone. Since the tile is adhered to the bottom of the pool while its expanding and contracting it can easily crack and break if the cement its laid into doesnt stretch with it. Therefore the question often heard from customers is "How do I install glass tile in my pool without having to repair the broken tiles year after year?" The answer has not always been an easy one. However with advances in technology and contractors growing experience installing glass tile we are now able to provide customers with the right recommendations so that their pool installation experiences minimal problems.
In situations where glass tile is exposed to extreme temperature differences an elasticizing polymer is added to the mix allowing the grout to stretch and flex preventing breaks from occurring in the delicate glass tiles. Using a grout float scoop a manageable amount of grout onto the float. Start at the farthest or highest spot away from you and spread the grout in between the tiles diagonally across the pattern. Dont worry about getting grout all over the tiles. The grout must be firmly pressed into the grout lines with the grout float covering all spaces and voids. Once a 3x3 section of grout has been applied to the tile use the small rubber edge of the grout float to remove about a third of the grout from between the tiles.