Glass Tile / January 6, 2019 / Fealty Allaire
A tile backsplash is a technique in interior designing that could improve the décor of your home especially in the kitchen and bathroom area. It refers to the installation of tiles to protect your walls primarily from water splashes. However tile backsplashes are not limited to the kitchen or bathroom area. Although the main use of this technique is for protecting the walls of water splashes you can use it anywhere in your home. You may use it to refurbish your fireplace or give a new glimmering effect to your walls. There are different kinds of tile backsplashes and one of them is the glass tile backsplashes. How can this type of tile backsplash improve the décor of your home? With glass tiles you create an illusion of wider kitchen space or any space in your home. Glass tiles reflect light from the surrounding environment which make your space look brighter and wider.
In situations where glass tile is exposed to extreme temperature differences an elasticizing polymer is added to the mix allowing the grout to stretch and flex preventing breaks from occurring in the delicate glass tiles. Using a grout float scoop a manageable amount of grout onto the float. Start at the farthest or highest spot away from you and spread the grout in between the tiles diagonally across the pattern. Dont worry about getting grout all over the tiles. The grout must be firmly pressed into the grout lines with the grout float covering all spaces and voids. Once a 3x3 section of grout has been applied to the tile use the small rubber edge of the grout float to remove about a third of the grout from between the tiles.
The reason so much more grout is removed than when grouting conventional tile is because light refracts better through the glass tile when the sides of the tiles are exposed to the light. Work 3x3 spaces for about ½ hour or until the grout begins to dry then sponge off the grout. Bring several buckets of clean water and a sponge to the work area before you begin. Soak up some water into the sponge and gently wipe away the excess grout that is adhered to the tile. Smooth the grout lines with the sponge using one continuous swipe. Flip the sponge over and swipe more grout from the tiles until it becomes full of grout. Rinse the sponge in a clean bucket of water and repeat.