Natural Stone / August 23, 2018 / FifineAsselin
Always take care to wear hand and eye protection as well as suitable clothing and remove and power sockets or electrical equipment that is likely to get wet in the process. When marking a cut line on a natural stone tile you may prefer to use a crayon as opposed to a pencil which is likely to not make a significant mark on the tile. Take care to go extra slow when reaching the end of your cut as if you go too fast and force the tile through it is likely to break rendering it difficult to use. If you are cutting a particularly large tile try to get someone to help you steady the tile as you cut since the weight of either piece of tile can start to pull the whole piece apart - encouraging a snap - as you advance through the tile.
On the other hand if there is a crack it might be of cheap quality. Water absorption: A real stone irrespective of whether it is exterior or interior natural stone tiles will not take in water even to a slight extent. This is why they are used these days in wet surfaces like bathrooms swimming pools Jacuzzis and even other areas where wetness is highly possible. When an individual is looking to purchase other types of tiles for his bathroom the water absorption capacity should be checked. Resistance to weather: Some types of floor tiles are chemically and synthetically designed. But exterior natural stone tiles have the innate ability to withstand even tough weather conditions. When a homeowner opts for the one with inferior quality rain sleet snow and wind can cause serious damage to his property.
This should not be counted as a negative side to natural stone tiles as there are ways to maintain them and we must bear in mind that any natural products requires maintenance. Once natural stone tiles are laid there are three steps that must be done to maintain the tiles which includes filling washing and sealing. This process must be repeated every two to five years depending on the quality of natural stone. The first step after laying the tiles is to fill them. All the holes must be filled with filler of the same color. Any gap between the tiles must be grouted. You need to allow one to two days for the filler and grout to be dried.