Natural Stone / September 4, 2018 / FifineAsselin
Always take care to wear hand and eye protection as well as suitable clothing and remove and power sockets or electrical equipment that is likely to get wet in the process. When marking a cut line on a natural stone tile you may prefer to use a crayon as opposed to a pencil which is likely to not make a significant mark on the tile. Take care to go extra slow when reaching the end of your cut as if you go too fast and force the tile through it is likely to break rendering it difficult to use. If you are cutting a particularly large tile try to get someone to help you steady the tile as you cut since the weight of either piece of tile can start to pull the whole piece apart - encouraging a snap - as you advance through the tile.
It is time to get price quotes. These should be thoroughly researched and in written format so that you can compare more easily. Do not just take the word of the person since then you have no sort of contract with the person. Overall when finally deciding that it is time to remodel you need to make sure that you are completely comfortable with your decision of contractor and that they do know how to use natural stone tiles. There is nothing worse than realizing that you hired a dud since it means that the remodel of your dreams is not turning out as planned or it is taking longer than necessary. Natural stone tiles handle just like any other type of ceramic tile however have the look of stone.
Using the edge of a trowel generously fill in the gaps between your tiles (created by using spacers) and smooth it over the surface at a 45 degree angle to the floor. A grout profiling tool can help after youve applied the grout to smooth the fill off and remove any unwanted excess. Caring for your natural stone tiles it an important to remember and before you finish your tiling job you need to seal the tiles to prevent the stone from becoming stained. This seal needs to be applied after tiles have been cleaned and any residual dust adhesive or grout has been removed with a residual remover. After applying and removing the residual remover a seal can then be added to help prevent materials and liquids from entering the pores of the stone and leaving potential marks. This seal needs to be regularly maintained in order to keep the tiles in good condition and can even be added to through the use of enhancing products to bring out the natural grain and contrasts of the stone.