Natural Stone / September 4, 2018 / FifineAsselin
Whenever you have a plan of placing a grout in your natural stone tile you should allow 1-2 days from when you applied the adhesive before beginning to grout. Always make sure that you clean the grout joints thoroughly and have taped off the areas which are not included in grouting in order to avoid grout from spilling over the tile. Mix the grout according to manufacturers specifications. It should have a fine consistency in order to have a fine and lump-free finished product. After you have done pouring all the natural stone tile joints with grout clean the surface of the tile with damp cloth after 10 minutes but be sure not to wipe out the grout from any of the tile joints.
Natural stone tiles may not be the easiest material to use and maintain for walls and flooring but they are certainly one of the most rewarding both in terms of quality and also return on investment since it is widely believed that a natural stone wall or floor will increase the value of your property. In addition to these benefits natural stone tiles also are extremely hard wearing and in most cases with some care and attention will last as long as the house does. As already mentioned there is perhaps more work involved both in fitting and maintaining natural stole tiles than there is in some alternatives such as wood flooring.
Using the edge of a trowel generously fill in the gaps between your tiles (created by using spacers) and smooth it over the surface at a 45 degree angle to the floor. A grout profiling tool can help after youve applied the grout to smooth the fill off and remove any unwanted excess. Caring for your natural stone tiles it an important to remember and before you finish your tiling job you need to seal the tiles to prevent the stone from becoming stained. This seal needs to be applied after tiles have been cleaned and any residual dust adhesive or grout has been removed with a residual remover. After applying and removing the residual remover a seal can then be added to help prevent materials and liquids from entering the pores of the stone and leaving potential marks. This seal needs to be regularly maintained in order to keep the tiles in good condition and can even be added to through the use of enhancing products to bring out the natural grain and contrasts of the stone.