Natural Stone / September 4, 2018 / FifineAsselin
Let us get into the details about the three points to be considered during the purchase: Solidity: This is pretty an easy thing to measure and people can judge the solidity of the product by breaking it. If it is hard to break the buyer can be satisfied that he has the right natural stone in his hand. Also he can try to drop a hammer from a good height for testing whether it breaks. In some showrooms there will be a separate space for conducting this type of tests on the stones. The dealers provide this sort of space just because of the fact that they are highly confident about the quality of the product that they deal with. If it is of the best quality there will not even be a mark of the hammer.
Out of all the natural stone materials Sandstone is the most absorbent; Travertine Limestone and Slate all have a medium absorbency while Granite is pretty much waterproof. It is also known that any polished materials will also absorb less water. The next factor to consider it the quality of the materials which is measured in grade. Grade can refer to the size shape and thickness of the tiles along with the condition of its surface. The most common grading systems use three levels of quality. Grade 1 is the highest quality. Everything is uniform and there are virtually no flaws. Grade 2 refers to any materials that have minor defects such as chips scratches or an irregular surface. Grade 3 materials have noticeable major flaws in size shape surface or chipping which makes them only appropriate as accent pieces or used in rustic decorative pieces. The next thing to think about is the coefficient of friction.
Using the edge of a trowel generously fill in the gaps between your tiles (created by using spacers) and smooth it over the surface at a 45 degree angle to the floor. A grout profiling tool can help after youve applied the grout to smooth the fill off and remove any unwanted excess. Caring for your natural stone tiles it an important to remember and before you finish your tiling job you need to seal the tiles to prevent the stone from becoming stained. This seal needs to be applied after tiles have been cleaned and any residual dust adhesive or grout has been removed with a residual remover. After applying and removing the residual remover a seal can then be added to help prevent materials and liquids from entering the pores of the stone and leaving potential marks. This seal needs to be regularly maintained in order to keep the tiles in good condition and can even be added to through the use of enhancing products to bring out the natural grain and contrasts of the stone.