Glass Tile / September 3, 2018 / FifineAsselin
Clean water is the key to finishing the job quickly and thoroughly. Once the tiles have been cleaned check for any voids or pits and fill them in as needed. Use the sponge and clean water to wipe away any remaining grout. Allow to dry for a few hours and then use a dry cheese cloth to clean the remaining grout residue. After the glass tile has dried for 48 hours its ready for use! Glass tile is not only beautiful to look at its also quite versatile. The Romans were known to use mosaic tiles all over their empire to create a feeling of home and to add religious pictorial and decorative significance to rooms of their homes. So if youd like to do as the Romans did get yourself some tiles.
Choosing the right grout color to match your glass tile is essential to preventing blemishes and imperfections from being easily spotted. Because of the reflective surfaces on these tiles grout can disrupt the refraction of light easily catching the eye and revealing blemishes in the tiles. A suitable match is one that is similar in color to the tiles color. Mixing grout is as simple as making pancake batter. Use a paddle bit and a ½" drill to mix non-sanded grout into a five gallon bucket stirring in water slowly. Once the mix has achieved the consistency of pancake batter the grout will be mixed to perfection. Add more water or more grout as needed to thin or thicken the grout mix.
Consumers need to consider that many mesh backed material use poor quality glue to bond the tile to the mesh. When the mesh side is installed to the surface the mesh acts as a barrier between the tile and substrate. If the glue subsequently breaks down or the bond fails the tile can then easily loosen and fall out because little of the tile surface is actually bonded to the substrate. This failure can begin almost immediately or can take up to a few years after all installation warranties have expired. With Chinese produced glass tile my experience has shown the glue used to bond the tile to the mesh is lower in quality than the glue used in higher quality products produced in Europe or quality US manufacturers.