Metal Tile / August 31, 2018 / FifineAsselin
However you use these tiles in your home make sure to look around before making your final purchase. You should never just settle on a tile because you cant find the color or pattern that you really want. Where you put this tile and how well it blends with the rest of your room will determine whether the decor is a warm success or a strange blunder. Metal tiles are becoming quit popular with those who are looking for a special design feel and for a design that is not considered an common tile type they available where ever tiles are sold. Most place that carry tile carry a number of brands and a variety of colors and material if you can not find what you are looking for dont be afraid to ask for help what youre looking for may not be displayed out front that does not mean that they do not carry the item youre looking for.
Setting out Setting out the roofing before installation is a major part of any new roof build. With metal tile roofing it is imperative to get the correct gauge right from the start. Unlike concrete tiles that have a certain amount of play in the gauge measurements metal tiles have to be spot on or they will not fit. For this reason it is common practice to use set out pins to ensure accurate fixing of the batons. A measuring stick is used to mark the gauge up the rafter before driving in the set out pins. The batons are then cut in place before being lifted clear to allow the building paper to be laid. It is possible to cut down the setting out time by half by building a separate smaller gauging rod.
The tiles must be tight and correctly aligned. The bottom and top course is then marked using a bevel. Two people may now chalk a line along the length of the valley. This gives a much straighter line than individual measurements. Laying the tiles Contrary to other roofing practices pressed steel tiles are best laid from the ridge down. Lay the under lap into the prevailing wind. This will ensure the maximum wind resistance and stop the roof lifting. The first full top course is laid out and fixed at the head of the tile allowing the subsequent row to be slid underneath the bottom. It is important to even out the tiles to make the best use of the cut ends.