Metal Tile / August 28, 2018 / FifineAsselin
In addition to shopping in terms of price one should become acquainted with the makeup of the various types and styles. Once you have gained some familiarity in terms of tile composition you may be in a much better position to make the right choice to suit your needs. If you enjoy the look of slate roofs cedar shake roofs or the signature Mediterranean clay tiles but do not have it within your budget to use these particular materials consider the option of metal tile roofing. There has been an amazing explosion of styles colors and textures in the manufacturing of these particular roofing elements. You can now have the look you want for a smaller investment than that required for the actual slate wood or clay.
For copper you have a few choices unless you have sealed the surface. You may allow the metal tiles to age and simply clean them on a regular basis using water and soap. You may also use a copper cleaner if you want your metal accent tiles for backsplash to remain shiny. However patina copper tiles have a clear coat protection so it will not do any good if you use a copper cleaner on them. Instead just stick to water and soap to keep them clean. You have to apply special care on titanium tiles even if they are only titanium-colored. Never use water and soap on them. Instead prepare a solution with equal parts of water and vinegar and then apply it on the tiles using a clean dry cloth to keep them shiny and clean.
The smaller rod is used to fix batons around hips and valleys and saves a lot of time messing around with a tape. Cutting and bending At roof terminations and intersections tiles are cut to fit allowing for a 50mm bend in the tile. It is this turn up/down that provides the waterproofing of the roof. It is important to bend a sufficient upturn or water may be blown under the ridge or hip. I have found by taping the jaws of the bender with several layers of duct tape it allows the tiles to be gripped firmer without damaging the paint of the tile. Aim to use half the tile per cut. This will leave you enough metal to get another cut for the opposing side. Valley cutting Marking and cutting the valley at ground level gives a much neater appearance. Instead of measuring each tile cut individually the tiles are laid along the ground as if they were on the roof.