Glass Tile / September 1, 2018 / FifineAsselin
There normally is not a concern with seeing the mesh backing through this tile. The same precautions still need to be taken into consideration for installation as well. The last thing to take into consideration is the grout. To play it safe the best grout to use is either an un sanded grout or specialty grout. The reason you will wand an un sanded grout is there is no sand particles in the unsanded grout. Sand particles found in sanded grout can possibly scratch the surface of the glass. The specialty grouts do not have any sand particles in them including the epoxy grout and urethane grouts. Home owners who want to make their kitchen pools or bathrooms look good often consider using glass tile. However these tiles can be quite pricey and can end up costing a person more when it comes to construction and renovation projects.
Since they dont have any color in it and are totally transparent they match any color from granite counter tops to kitchen cabinets and easily blend into the environment. Stained and Plain Clear Glass Tiles require more attention when installing. Because you can see what is on the other side of the tile you may end up seeing the path made by the trowel when the installer was butting the wall. So it is recommended to use a white adhesive such as mastic and also butter the back of the tiles. Make sure to press the tiles firmly against the wall with a grout float and take a look if there is any air bubbles after each piece has been placed so you may correct the problem before the adhesive dries. Definitely this type of glass tiles takes more time to install but the result is absolutely worth. Glass tile is all the rage in interior decorating right now but the real star is recycled glass tile.
In situations where glass tile is exposed to extreme temperature differences an elasticizing polymer is added to the mix allowing the grout to stretch and flex preventing breaks from occurring in the delicate glass tiles. Using a grout float scoop a manageable amount of grout onto the float. Start at the farthest or highest spot away from you and spread the grout in between the tiles diagonally across the pattern. Dont worry about getting grout all over the tiles. The grout must be firmly pressed into the grout lines with the grout float covering all spaces and voids. Once a 3x3 section of grout has been applied to the tile use the small rubber edge of the grout float to remove about a third of the grout from between the tiles.