Glass Tile / January 20, 2019 / Astrid Auclair
Most quality manufacturers sponsor minimum of two-day seminars to ensure a finished look that will last decades rather than months. A Phoenix Arizona based company recently conducted two-day seminars bringing Alex Arcaro of Bisazza to their Scottsdale showroom to teach contractors the fine art of glass tile installation. The benefit of a "paper faced glass tile" is that it allows for an efficient method of installation and is used by quality glass tile manufacturers. When installing a paper faced material 100% of the glass tile is bonded to the substrate which has tremendous benefits especially if it is being used in wet area applications.
Both trendy and good for the earth read on to learn why your next decorating project should involve recycled glass tiles. One of the benefits of recycled tile is that the abundance of wasted glass in landfills is put to good use leaving the land free to be utilized for more biodegradable material. (This also means that landfills dont need to be expanded to accommodate the rising amount of glass waste.) Recycled glass tile is also better for the environment because it takes take less than half the energy required to produce other forms of tile. Additionally when you move on to other decorating themes you can re-recycle your recycled tiles too! Recycled glass tile is easy to install easy to clean and looks great in any room including shower stalls bathroom and kitchen floors as well as backsplash areas.
Consumers need to consider that many mesh backed material use poor quality glue to bond the tile to the mesh. When the mesh side is installed to the surface the mesh acts as a barrier between the tile and substrate. If the glue subsequently breaks down or the bond fails the tile can then easily loosen and fall out because little of the tile surface is actually bonded to the substrate. This failure can begin almost immediately or can take up to a few years after all installation warranties have expired. With Chinese produced glass tile my experience has shown the glue used to bond the tile to the mesh is lower in quality than the glue used in higher quality products produced in Europe or quality US manufacturers.