Glass Tile / January 21, 2019 / Annette Laforest
There normally is not a concern with seeing the mesh backing through this tile. The same precautions still need to be taken into consideration for installation as well. The last thing to take into consideration is the grout. To play it safe the best grout to use is either an un sanded grout or specialty grout. The reason you will wand an un sanded grout is there is no sand particles in the unsanded grout. Sand particles found in sanded grout can possibly scratch the surface of the glass. The specialty grouts do not have any sand particles in them including the epoxy grout and urethane grouts. Home owners who want to make their kitchen pools or bathrooms look good often consider using glass tile. However these tiles can be quite pricey and can end up costing a person more when it comes to construction and renovation projects.
Most quality manufacturers sponsor minimum of two-day seminars to ensure a finished look that will last decades rather than months. A Phoenix Arizona based company recently conducted two-day seminars bringing Alex Arcaro of Bisazza to their Scottsdale showroom to teach contractors the fine art of glass tile installation. The benefit of a "paper faced glass tile" is that it allows for an efficient method of installation and is used by quality glass tile manufacturers. When installing a paper faced material 100% of the glass tile is bonded to the substrate which has tremendous benefits especially if it is being used in wet area applications.
In situations where glass tile is exposed to extreme temperature differences an elasticizing polymer is added to the mix allowing the grout to stretch and flex preventing breaks from occurring in the delicate glass tiles. Using a grout float scoop a manageable amount of grout onto the float. Start at the farthest or highest spot away from you and spread the grout in between the tiles diagonally across the pattern. Dont worry about getting grout all over the tiles. The grout must be firmly pressed into the grout lines with the grout float covering all spaces and voids. Once a 3x3 section of grout has been applied to the tile use the small rubber edge of the grout float to remove about a third of the grout from between the tiles.