Metal Tile / June 30, 2018 / FifineAsselin.
These days more and more people are keeping up with the trend of using metal tiles as accent tiles in their backsplash. They are unique attractive and easy to install; in fact anyone with DIY skills can install them. Aside from their charm metal accent tiles are also quite easy to maintain. Like other things in the house you will eventually need to clean metal tiles to keep them looking good as new. You may use different types of maintenance and care for metal accent tiles depending on the type of metal tile you have and the effect that you want. For instance copper may be stained when it is exposed to moisture and air unless you seal it. However there are some people who prefer this type of aging.
Steel vendors who comply with such regulations put coil numbers on each item so you and they will know when exactly were the metal purchased. If this is not present you have no protection even if they say that such a warranty exists. Using metal tile on walls or in other kinds of applications is not just a fad. Metal has been used for tile nearly as long as ceramic or other common materials have. Metal wall tile is elegant and has a timeless classy look that sets it apart while at the same time complimenting traditional tile. Different metals used for tiling include copper stainless steel and other exotic metals. The kitchen is one of the most common areas for metal to be used.
Setting out Setting out the roofing before installation is a major part of any new roof build. With metal tile roofing it is imperative to get the correct gauge right from the start. Unlike concrete tiles that have a certain amount of play in the gauge measurements metal tiles have to be spot on or they will not fit. For this reason it is common practice to use set out pins to ensure accurate fixing of the batons. A measuring stick is used to mark the gauge up the rafter before driving in the set out pins. The batons are then cut in place before being lifted clear to allow the building paper to be laid. It is possible to cut down the setting out time by half by building a separate smaller gauging rod.
The tiles must be tight and correctly aligned. The bottom and top course is then marked using a bevel. Two people may now chalk a line along the length of the valley. This gives a much straighter line than individual measurements. Laying the tiles Contrary to other roofing practices pressed steel tiles are best laid from the ridge down. Lay the under lap into the prevailing wind. This will ensure the maximum wind resistance and stop the roof lifting. The first full top course is laid out and fixed at the head of the tile allowing the subsequent row to be slid underneath the bottom. It is important to even out the tiles to make the best use of the cut ends.