Glass Tile / September 3, 2018 / FifineAsselin.
The first type of tile is a translucent glass. A translucent glass is a type of tile that you could actually hold up and see right through it. The most common types of glass that is translucent is a recycled glass or an oval penny round or brick type of tile. Majority of translucent glass tiles are paper faced. The reason that most of these are paper faced is because the mesh backing can be seen through the glass tile. When installing this type of glass tile you want to use a small notch trowel when spreading your mastic on the installation surface. After spreading the mastic you will want to flatten down or knock down the trowel marks.
The most important step in putting glass tile in a swimming pool is choosing the right installation materials. To reiterate the high rate of expansion and contraction of glass caused by temperature changes is the leading cause of cracks and damage to installed tiles. In order to compensate for this special thin-set adhesives and additives have been developed that expand and contract with the glass. The leading manufacturer of glass-specific tile adhesive systems is MAPEI and their Adesilex P10 thin-set and Keraply additive can be combined into an installation system that is specifically designed for applications where the glass tiles are completely submerged.
Quality mosaics offer the clients designers and architects few if any limitations on their visions. Almost anything can be designed and made from quality glass tile including furniture. The best word of advice when considering glass tile is a consumer should always consult with an authorized distributor regarding the tiles suitability for the intended use. Authorized distributors spend an enormous amount of time educating their employees and they always know who to contact for installation related questions. Please contact your distributor for a list of installers who have completed formal training. Are you looking for a one of a kind way to dress up a glass block shower wall or window? If so youll want to check out the newly introduced decorative blocks with fused glass tiles added to them.
The reason so much more grout is removed than when grouting conventional tile is because light refracts better through the glass tile when the sides of the tiles are exposed to the light. Work 3x3 spaces for about ½ hour or until the grout begins to dry then sponge off the grout. Bring several buckets of clean water and a sponge to the work area before you begin. Soak up some water into the sponge and gently wipe away the excess grout that is adhered to the tile. Smooth the grout lines with the sponge using one continuous swipe. Flip the sponge over and swipe more grout from the tiles until it becomes full of grout. Rinse the sponge in a clean bucket of water and repeat.