Natural Stone / September 10, 2018 / FifineAsselin
Using the edge of a trowel generously fill in the gaps between your tiles (created by using spacers) and smooth it over the surface at a 45 degree angle to the floor. A grout profiling tool can help after youve applied the grout to smooth the fill off and remove any unwanted excess. Caring for your natural stone tiles it an important to remember and before you finish your tiling job you need to seal the tiles to prevent the stone from becoming stained. This seal needs to be applied after tiles have been cleaned and any residual dust adhesive or grout has been removed with a residual remover. After applying and removing the residual remover a seal can then be added to help prevent materials and liquids from entering the pores of the stone and leaving potential marks. This seal needs to be regularly maintained in order to keep the tiles in good condition and can even be added to through the use of enhancing products to bring out the natural grain and contrasts of the stone.
You should do three sponging cycles in order to maintain the cleanliness and stunning of the tile. The purpose of the first sponging is to clean the excess grout over the tile second is to smoothed the joints and third is to clean any residue left on the tile. However you have to allow minutes of time between sponging cycles because this allow the grout to set properly. Also be reminded that use the clean side of the sponge when wiping and cleaning the tile after grouting. And lastly wipe down the tile the next day to help seal the grout and to clean the tile as well. Always make sure that you use the correct sealant labeled for natural stone tile in order to maintain the appearance of the natural stone tile. Many people complain about natural stone floor tiles absorbing dirt or start developing holes after few years.
They should then explain in detail what they are looking for when they do the remodel. It is best for the homeowner if they have specific ideas and plans laid out so that the contractor fully understands what they are getting themselves into. When telling the contractor of your plans be sure to tell them that you want to use natural stone tiles. This way if the contractor has some sort of hesitation about working with the material you can cross that contractor off your list for those that you are considering hiring for your remodel. Natural stone tiles usually do not make contractors want to run from a project however some contractors may just not like working with the material since it does require a few extra tools that they may or may not have on hand. Once you get all of the information from the contractors and have narrowed down the list of just who can work with the materials that you have specified.