Glass Tile / January 8, 2019 / Fealty Allaire
According to Wes Wayland of Bisazza USA "It gives a client the ability to clad curved surfaces both concave and convex and to form clean inside and outside corners with more ease and a finished look. This also gives them the ability to create mosaics on furniture walls ceilings pools even cladding of entire buildings with unique designs". Glass tile isnt JUST for the bathroom anymore. Bisazza wants consumers and designers to think outside the box and are offering prefabricated mosaic patterns and designs intended to cover large vertical surfaces as wallpaper would and that are perfectly suited for the bedroom - living room - board room - foyer - etc.
In situations where glass tile is exposed to extreme temperature differences an elasticizing polymer is added to the mix allowing the grout to stretch and flex preventing breaks from occurring in the delicate glass tiles. Using a grout float scoop a manageable amount of grout onto the float. Start at the farthest or highest spot away from you and spread the grout in between the tiles diagonally across the pattern. Dont worry about getting grout all over the tiles. The grout must be firmly pressed into the grout lines with the grout float covering all spaces and voids. Once a 3x3 section of grout has been applied to the tile use the small rubber edge of the grout float to remove about a third of the grout from between the tiles.
Consumers need to consider that many mesh backed material use poor quality glue to bond the tile to the mesh. When the mesh side is installed to the surface the mesh acts as a barrier between the tile and substrate. If the glue subsequently breaks down or the bond fails the tile can then easily loosen and fall out because little of the tile surface is actually bonded to the substrate. This failure can begin almost immediately or can take up to a few years after all installation warranties have expired. With Chinese produced glass tile my experience has shown the glue used to bond the tile to the mesh is lower in quality than the glue used in higher quality products produced in Europe or quality US manufacturers.