Glass Tile / August 29, 2018 / FifineAsselin.
Choosing the right grout color to match your glass tile is essential to preventing blemishes and imperfections from being easily spotted. Because of the reflective surfaces on these tiles grout can disrupt the refraction of light easily catching the eye and revealing blemishes in the tiles. A suitable match is one that is similar in color to the tiles color. Mixing grout is as simple as making pancake batter. Use a paddle bit and a ½" drill to mix non-sanded grout into a five gallon bucket stirring in water slowly. Once the mix has achieved the consistency of pancake batter the grout will be mixed to perfection. Add more water or more grout as needed to thin or thicken the grout mix.
Consumers need to consider that many mesh backed material use poor quality glue to bond the tile to the mesh. When the mesh side is installed to the surface the mesh acts as a barrier between the tile and substrate. If the glue subsequently breaks down or the bond fails the tile can then easily loosen and fall out because little of the tile surface is actually bonded to the substrate. This failure can begin almost immediately or can take up to a few years after all installation warranties have expired. With Chinese produced glass tile my experience has shown the glue used to bond the tile to the mesh is lower in quality than the glue used in higher quality products produced in Europe or quality US manufacturers.
Although the definition of clear/translucent glass is "allowing light to pass through partially or diffusely" it doesnt mean that all clear glass tiles are transparent in a way that you can see for example an object or your hand behind it. Clear glass is the material used to make these tiles but they can have color or not. There are basically three types of clear glass tiles: back colored stained and plain or non-colored. Back colored clear glass mosaic tiles are by far the most popular in the market. The tiles are made of clear/translucent glass usually from 4mm to 8mm thick and they receive a coating/painting on the back during manufacturing which is what gives the color to the tile.
In situations where glass tile is exposed to extreme temperature differences an elasticizing polymer is added to the mix allowing the grout to stretch and flex preventing breaks from occurring in the delicate glass tiles. Using a grout float scoop a manageable amount of grout onto the float. Start at the farthest or highest spot away from you and spread the grout in between the tiles diagonally across the pattern. Dont worry about getting grout all over the tiles. The grout must be firmly pressed into the grout lines with the grout float covering all spaces and voids. Once a 3x3 section of grout has been applied to the tile use the small rubber edge of the grout float to remove about a third of the grout from between the tiles.