Glass Tile / January 11, 2019 / Astrid Auclair
These are tiles that are made with the use of recycled glass taken from old bottles old windows and other glass items that no longer have any real use. These recycled tiles are made by grinding the old glass into a fine powder color is then added to this powder and the resulting mixture is then pressed into tile molds. These are then baked and cooled. Getting inexpensive tile is easy if you know where to look. Some of the best places for you to find these tiles are online or in home improvement stores near you. Just look for glass tiles in the sale area of these stores or in the discontinued section of these sites that sell them for cheap. To most tile retailers the largest customers are always the people tiling their pools.
In this method colors are added to the top or bottom of the glass. Fused glass tiles are characterized with a translucent area and a layer of opaque color visible through the tile. These tiles are further treated with an etching or other coating for aesthetics or abrasion. Sintered tile is a variety made by pressing glass powder into dies and then heated until the particles fuse. The color is either added into the powder or added topically after cooling. Unlike smalti tiles sintered tiles tend to have a uniform look. This milky and scratch-resistant finish makes it versatile. Cast tile is made by inserting chunks of glass into a mold which gives it a layered look.
Consumers need to consider that many mesh backed material use poor quality glue to bond the tile to the mesh. When the mesh side is installed to the surface the mesh acts as a barrier between the tile and substrate. If the glue subsequently breaks down or the bond fails the tile can then easily loosen and fall out because little of the tile surface is actually bonded to the substrate. This failure can begin almost immediately or can take up to a few years after all installation warranties have expired. With Chinese produced glass tile my experience has shown the glue used to bond the tile to the mesh is lower in quality than the glue used in higher quality products produced in Europe or quality US manufacturers.